Pelco es3012 사용자 설명서

14

Pelco Manual C306M-K (4/05)

When the Esprit system is powered up or reset, the selected protocol, revision number, and
other information is displayed on the monitor. For example, the screen might show the fol-
lowing information:

The information displayed depends on the selected protocol
(C, D, or P) and the menu selection for power-up mode.
(Refer to the 

Power-Up Mode in the Programming

 section).

The information remains on the monitor until the dome is
moved.

Move joystick left/right and up/down.

Scanning

Stop Scan

Call preset 96.

Random Scan

Call preset 97.

Frame Scan

Call preset 98.

Auto Scan

Call preset 99.

Refer to the documentation supplied with the controller.

Refer to the documentation supplied with the controller.

Refer to the 

Programming

 section and to the

documentation supplied with the controller.

For more information refer to 

Operating Notes

.

The operating temperature ranges from a minimum of -40°F (-40°C) to a maximum of 122°F
(50°C) for sustained system operation or 140°F (60°C) absolute maximum. The entire unit
can de-ice and be operational in two hours from a temperature of -13°F (-25°C). The thermo-
statically controlled heater consumes 10 watts and cycles on at 70°F (21°C) and off at 85°F
(29°C), while the window defroster runs continuously and consumes 2.5 watts.

(Capability, 360° Continuous

(Viewing Range, +40° to -90°)***

Pan Rotation)**

Fixed speed

Speed determined by

Speed determined by controller

controller

*Variable speed

0.5 to 40° per second,

0.5 to 20° per second, depending

depending on joystick position

on joystick position

*Turbo Mode

100° per second

Does not affect the tilt speed

*Preset Mode

100° per second

30° per second

*50 mph wind speed profile.

** If manual limit stops are set, “Pan Limit” appears on your monitor when a limit stop is

reached. This does not apply to scan limit stops.

*** When the system reaches the upper limit, “Tilt Limit” appears on your monitor.

D Address 1
P Address 2