VIVOTEK FD8167-(T) 사용자 설명서

 

 

IR cut filter

With a removable IR-cut filter, this Network Camera can automatically remove the filter to let IR 

light into the sensor during low light conditions�

■ Auto mode

The Network Camera automatically removes the filter by judging the level of ambient light.

■ Day mode

In day mode, the Network Camera switches on the IR cut filter at all times to block infrared light 

from reaching the sensor so that the colors will not be distorted�

■ Night mode

In night mode, the Network Camera switches off the IR cut filter at all times for the sensor to 

accept infrared light, thus helping to improve low light sensitivity�

■ Synchronize with digital input 

The Network Camera automatically removes the IR cut filter when a Digital Input is triggerred.

■ Schedule mode

The Network Camera switches between day mode and night mode based on a specified 

schedule. Enter the start and end time for day mode. Note that the time format is [hh:mm] and is 

expressed in 24-hour clock time. By default, the start and end time of day mode are set to 07:00 

and 18:00.

Light sensor sensitivity

Select Low, Normal, or High sensitivity for the light sensor� 

If there is an object in close proximity, the IR lights 

reflected back from it can mislead the Smart IR’s 

calculation of light level� To solve this issue, you 

can place an “Exposure Exclude” window on an 

unavoidable object in the Exposure setting window� 

You can also configure the “Exposure Exclude” 

window in a night mode “Profile” setting so that your 

day time setting is not affected�