Avaya 03-300430 사용자 설명서

If the circuit pack is properly administered and the red LED is still on, follow the instructions 
for 

c. Error Type 2: Windows 2000 is down and the system attempts to reset the board. If the 

reset fails, the board may be bad.

1. Replace the circuit pack.

d. Error Type 18: The circuit pack has been busied out.

1. Release the board (release board location).

e. Error Type 23 and 1025: The MAPD-BD circuit pack is not completely administered. 

To be fully administered, a MAPD circuit pack must:

●

Have an entry in the circuit plan (change circuit-pack)

●

Be administered (add ds1 location)

●

Be physically inserted into the correct slot

The MAPD circuit pack differs from others in that inserting it into the switch backplane is not 
enough to make the board usable.

f. Error Type 125, no Aux Data: A wrong circuit pack is inserted in the slot where this circuit 

pack is logically administered. To resolve this problem:

●

Remove the wrong circuit pack and insert the logically administered circuit pack

or

●

Re-administer the slot (change circuit-pack) to match the circuit pack inserted.

g. Error Type 257 is associated with the Common Port circuit pack maintenance test. See 

on page 2539 for details.

h. Error Type 513: Transient hardware problem, where Aux Data:

1. If the same Error Type/Aux Data value occurs more than once in a 24-hour period, the 

circuit pack should be replaced. See 

before removing the circuit pack.

If the MAPD board detects only one of these hardware problems, then the error is resolved 
when none of these faults are detected for 10 minutes.

i. Error Type 514: LAN External RAM Error; hardware fault in the PPE external RAM, used for 

message buffering to and from the packet bus. This error should not occur regularly.

1. If this error occurs 10 times within 30 minutes, replace the circuit pack. See 

on page 1529 before removing the circuit pack.

4352

External RAM failure

4353

Internal RAM failure

4355

Internal ROM failure