Avaya 03-300430 사용자 설명서

This test applies momentary ringing voltage to the terminal equipment and monitors resulting 
current flow to determine whether terminal equipment is connected to the port. This test may 
cause some terminal equipment to ring briefly during daily maintenance. If this ringing disturbs 
the customer or the terminal equipment, you can disable it via the Tests field on the change 
station screen. However, on some software releases, Tests #6, 7, 161, and 35 are disabled.

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

1000

ABRT

System resources required to run this test are not available.  The port may 
be busy with a valid call.

1. If the port status is idle, then retry the command at 1-minute intervals a 

maximum of 5 times.

1004

ABRT

The port was seized by a valid call during the test.  The test has been 
aborted.

1. Use display port location to determine the station extension.
2. Use status station to determine the service state of the port. If 

the service state indicates that the port is active, wait until it is idle.

3. Retry the command at 1-minute intervals up to 5 times.

1005

ABRT

The test was aborted due to a configuration problem.  This test may not be 

applicable, or it may be disruptive to terminal equipment other than a voice 

terminal (for example, the modem pool member or Music On Hold).

1008

ABRT

Could not allocate a ringing circuit.  Either every ringing circuit is active or 

the ringing generator is either defective or incorrectly wired.  
Retry the command at 1-minute intervals up to 5 times.

1. If the test continues to abort, look for RING-GEN errors in the Error 

Log.  If an ABORT 1008 occurs for this test on other circuit packs as 
well, then the ringing generator may be defective or is incorrectly 
wired.  If it does not occur on other ports, then all four ring phases are 
active.

 1 of 3