Avaya 03-300430 사용자 설명서

1018

ABRT

Test disabled by administration. Verify that the Maintenance Tests? field 

on the Trunk Group form is set to n. To enable the test, enter change 

trunk-group x (x is the trunk group number). Enter y in the 

Maintenance Tests field.

1412

ABRT

This test does not execute on a G700 Media Gateway.

2000

ABRT

Response to the test was not received within the allowable time period.

1. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

System resources required to run this test are not available. This may be 
due to the port being seized.

1. This abort code is usually associated with tone-clock (TONE-BD, 

TONE-PT, and TDM-CLK) resources. Clear any tone errors in the 
error log.

2. Retry the command at 1-minute intervals up to 5 times. 

3

FAIL

The nonreflective 1004-Hz tone test of the port failed. An echo was 

detected from the port. Poor-quality transmission was detected to or from 

the port. The problem may be off-board. See additional information for this 

error code below. 

CAUTION:

The port may still be operational, or the fault may be 
off-board (connections or CO). Off-board problems include 
incoming seizures or off-hook port seizures during the test 
and, perhaps, noise induced by adjacent electric power 
lines. The test may be disabled from the trunk 
administration 'Test' field. This turns off all testing for that 

trunk group except for tests 6 and 36.

 2 of 5