Vermont Casting 2550CE 사용자 설명서

21

Below you will find important information on general 
care, inspection and maintenance of your Vermont 
Castings stove. Should it become necessary, use only 
replacement parts recommended by your authorized 
dealer.

Let the fire in the stove go out and allow the stove to 
cool completely before beginning any maintenance 
procedure.

An occasional dusting with a dry rag will keep the painted 
cast iron of your Encore looking new.  
The stove’s paint can be touched up as needed. First, 
mask the areas, such as enamelled parts,  glass, or 
handles, around the spot  to be painted. Clean the spot 
with a wire brush. Remove the griddle and set it aside.  
Then, touch up the stove with Vermont Castings’ high 
temperature stove paint. Apply the paint sparingly; two 
light coats of paint are better than a single heavy one.

Use a dry or slightly damp rag or soft brush to remove 
spills or stains.  For difficult jobs that require a cleaning 
agent, use only a kitchen appliance cleaner or polish 
recommended for use on enamel surfaces.  

Most of the carbon deposits on the glass will burn off 
during hot fires.
However, the ash residue that accumulates on the 
glass surface should be removed regularly to prevent 
etching. To clean the glass, follow this procedure:

• 

Be sure the glass is completely cool.

• 

Clean the glass with water or a cleaner made espe-
cially for this purpose. Do not use abrasive cleaners.

• 

Rinse the glass thoroughly.

• 

Dry the glass completely.

Do not operate your stove if the glass in the doors is 
damaged.
If you need to replace the glass, use only the high tem-
perature ceramic glass supplied by Vermont Castings. 
Do not use substitutes. Be sure to specify left or right 
glass; the panels are not interchangeable.

The left door is slightly different from the right in that 
one of its retainer clips is located under the door mani-
fold.     
1.  Remove the right and left door assemblies by raising 

the door until the lower hinge pin clears its drilling; 
then, angle the door bottom slightly outward and 
pull down to release the upper hinge pin.  Place the 
doors face down on a padded work surface.

2.  Remove the screws that hold the retainer clips in 

place, and remove the clips. On the right door, re-
move the Phillips head machine screw that secures 
the door manifold to the upper right of the door (as it 
faces you). Swing the door manifold out of your way 
and remove the clip beneath it as well.

3.  Carefully lift the broken glass panel from the door.

ST640

Encore

door glass

3/01

Manifold

Retainer Clips (4)

Glass Panel

Gasket

ST640

Fig. 30  An exploded view of the glass assembly for the left 
door.

Check the gasket around the window; it should be soft 
and resilient so the glass will seal properly against the 
door. Replace the gasket if it has hardened or if it is 
compressed.
1.  Center the first pane of glass on the gasket. Be sure 

to place the glass so the infrared reflective coating is 
on the exterior side.

2.  Secure the glass on both doors with the retainer 

clips except the one that belongs under the manifold 
of the right door, but leave the screws a little loose.

  Position the remaining clip under the right door 

manifold, and swing the manifold back into position 
on the door. Make sure the screw passing through 
the end of the manifold nearest the center of the 
door also passes through the retainer clip.