Lochinvar F0600187510 사용자 설명서

다운로드
페이지 60
Installation and Service Manual
GENERAL PRODUCT 
INFORMATION
Special Instructions
This manual supplies information for the installation, operation
and servicing of this pool heater. Read and understand this manual
completely before installing the pool heater.
Installation and service must be performed by a qualified service
installer, service agency, or the gas supplier.
Unpacking
Upon receiving equipment, check for signs of shipping damage. Pay
particular attention to parts accompanying the pool heater which
may show signs of being hit or otherwise being mishandled. Verify
total number of pieces shown on  the packing slip with those
actually received. In case there is damage or a shortage, immediately
notify the carrier.
Codes
The equipment shall be installed in accordance with those
installation regulations in force in the local area where the
installation is to be made. These shall be carefully followed in all
cases. Authorities having jurisdiction shall be consulted before
installations are made. In the absence of such requirements, the
installation shall conform to the latest edition of the National Fuel
Gas Code, ANSI Z223.1 and/or CAN/CGA-B149 Installation Code.
All pool heater heat exchanger construction conforms to the latest
edition of the ASME Boiler and Pressure Vessel Code, Section IV,
Part HLW. 
Warranty
Factory warranty (shipped with pool heater) does not apply to pool
heaters installed or operated improperly.  Improper installation or
system design causes most operating problems.
1.  Excessive water hardness causing a lime build up in the copper
tube is not the fault of the equipment and is not covered under
the appliance manufacturer’s warranty (see Water Chemistry,
page 44).
2.  Excessive pitting and erosion on the inside of the copper tube
may be caused by too much water velocity through the tubes
and is not covered by the appliance manufacturer’s warranty. 
3. Corrosion due to water chemistry imbalance is not the fault of
the equipment and is not covered by the appliance
manufacturer’s warranty (see Water Chemistry, page 44).
The information contained in this manual is intended for use by
qualified professional installers, service technicians or gas suppliers.
Consult your local expert for proper installation or service
procedures.
SAFETY INFORMATION
IMPORTANT: Read this owner’s manual carefully
and completely before trying to install, operate, or
service this pool heater. Improper use of this pool
heater can cause serious injury or death from burns,
fire, explosion, electrical shock, and carbon
monoxide poisoning.
DANGER: Carbon Monoxide poisoning may
lead to death!
IMPORTANT: Consult and follow local building and
fire regulations and other safety codes that apply to
this installation. Consult your local gas utility
company to authorize and inspect all gas and flue
connections.
WARNING: Should overheating occur or the
gas supply fail to shut off, do not turn off or
disconnect the electrical supply to the pump.
Instead, shut off the gas supply at a location
external to the pool heater.
WARNING: To minimize the possibility of
serious personal injury, fire or damage to your pool
heater, never violate the following safety rules.
1. Pool heaters are heat producing appliances.  To avoid damage or
injury, do not store materials against the pool heater or the
vent-air intake system.  Use proper care to avoid unnecessary
contact (especially children) with the pool heater and vent-air
intake components.
2. Never cover your pool heater, lean anything against it, store
trash or debris near it, stand on it, or in any way block the flow
of fresh air to your pool heater.
3. UNDER NO CIRCUMSTANCES must flammable materials
such as gasoline or paint thinner be used or stored in the
vicinity of this pool heater, vent-air intake system or any
location from which fumes could reach the pool heater or vent-
air intake system.
4. This pool heater is only for use with the type of gas indicated on
the rating plate. 
3