Enerco TSVFB10LP 사용자 설명서

Installation Instructions and Owner’s Manual

Unvented Liquid Propane Fired Room Heater

WARNING: A qualified service person must install 

heater. Follow all local codes. 

Use only LP-gas. If your gas supply is not LP-gas, do 

not install heater. Call dealer where you bought heater 

for proper type heater.

Before installing heater, make sure you have the items 

listed below:

•

Piping (check local codes)

•

Sealant (resistant to LP_Gas)

•

Equipment shutoff valve*

•

Ground joint union

•

Test gauge connection*

•

Sediment trap

•

Tee joint

•

Pipe wrench

*A CSA/AGA certified equipment shutoff valve with 1/8” 

NPT tap is an acceptable alternative to test gauge con-

nection. Purchase a CSA/AGA certified equipment shutoff 

valve from your dealer. 

This heater is designed to be mounted on the wall. The 

heater can also be located on a non-combustible floor, 

away from a wall by using the floor mounting stands in-

cluded with the heater. If installed on combustible floor-

ing such as carpeting, tile or other combustible material 

other than wood flooring, the heater must be placed on 

a wood panel the full width and depth of the appliance. 

For convenience and efficiency, install the heater:

•

Where there is easy access for operation, 

inspection, and service.

•

In the coldest part of the room.

CAUTION: If you install the heater in a home garage:

•

Heater pilot and burner must be at least 18 

inches above floor . 

•

Locate heater where moving vehicle will not hit it. 

CAUTION: This heater creates warm air currents. These 

currents move heat to wall surfaces next to heater. Install-

ing heater next to vinyl or cloth wall covering or operat-

ing heater where impurities (such as tobacco smoke, 

aromatic candles, cleaning fluids, oil or kerosene lamps, 

etc.) are present in the air may discolor walls. 

WARNING: Never install the heater: 
•  In a recreational vehicle .

•

Where curtains, furniture, clothing, or other 

flammable objects are less than 36 inches from 

the front, top, or sides of the heater. 

•  As a fireplace insert 
•  In high-traffic areas 
•  In windy or drafty areas 
WARNING: Heater must be mounted to maintain 

the minimum clearances shown in Figure 4. If pos-

sible, provide greater clearances from the floor, ceil-

ing, and joining walls. 

The mounting bracket in located on the back panel of 

heater (see figure 5). It has been taped there for ship-

ping. Remove mounting bracket from back panel.

Removing Front Panel of Heater 

1.  Remove three screws on bottom front of front 

panel.

2.  Pull bottom of front panel forward, then down 

(see figure 6)

Attaching Mounting Bracket to Wall

Use holes on each end of mounting bracket to attach 

bracket to wall. These holes are 16 inches apart. Attach 

mounting bracket to wall in one of two following ways.

Left 

Side

Right 

Side

36” min. from 

ceiling

6” Min from 

adjoining 

walls

2” min. to top surface of carpet, tile 

or other combustible material

Floor