Dimplex DXLWP800TI N 사용자 설명서

다운로드
페이지 4
Models with Timer
DXLWP400TI, DXLWP800TI N & ARLWP800TI
Set the I - 
¡
¡
¡
¡
¡
 - O sli
de switch on the timer
(Fig. 3) to :
Position O - Heating Off
Position I - Manual operation
This setting allows power to the heater
uninterrupted by the timer settings. The
heat selector switch will control the output
(see ‘Using the heater’).
Position 
¡
¡
¡
¡
¡
 -  ‘Auto’ operation
DO NOT disconnect this heater from
the mains supply unless it is being
taken out of use (e.g. in summer or for
storage), otherwise the timer clock will
stop.
Setting the time of day
To set the time of day, rotate the timer
dial clockwise (indicated by the arrow)
until the correct time of day is opposite
the reference mark    (see Fig. 4).
The 24-hour clock is used ; e.g. time shown for 3 pm is ‘15’
(15:00hrs).
Setting the ‘Auto’ ON and OFF times
To set the timer :
1. Using your finger tip or the tip of a
pencil, push in as many segments as
necessary around the dial, according
to the times you don’t require heat –
see Fig. 4. Each segment pushed in
switches the heater OFF for that part of
the hour. All other segments will be ON.
For example, Fig. 5 shows the timer
set to switch the heater ON between 7
am and  9 am and between 4 pm and
9.30 pm .
2.  You can select as many ON periods
as you like, within the 24-hour day. The
settings will repeat every day until changed.
3. To change ON and OFF times, simply push in any ‘ON’
segments you wish to cancel and pull out new ‘ON’ segments
as required.
Switching to auto
Set the heat selector and thermostat for the heat output required.
Check that the 
clock shows the correct time of day. Set the
 I - 
¡
¡
¡
¡
¡
- O
 slide switch to 
 
¡
¡
¡
¡
¡
 (see Fig. 4)  - the convector will  switch ON
and OFF according to the timer settings (see Fig 5).
IMPORTANT NOTES
Remember to observe all safety warnings when operating the
heater on auto setting unattended or attended .
If the mains supply to the heater is interrupted, th
e timer clock
will stop until power is restored ; reset the time of day to ensure
correct ON and OFF times.
Fig. 3
11
15
13
12
14
O
I
Fig. 4
Fig. 5
11
O
12
13
15
I
14