Essick Air CP20 사용자 설명서

This warranty is extended to the original purchaser of an evaporative cooler installed and used under nor-
mal conditions.  It does not cover damages incurred through accident, neglect, or abuse by the owner.  We 
do not authorize any person or representative to assume for us any other or different liability in connection 
with this product.

For One Year from date of purchase, we will replace any original component provided by Champion 
Cooler which fails due to any defect in material or factory workmanship only.

We are not responsible for replacement of evaporative media.  These are disposable components and 
should be replaced periodically.  We are not responsible for any incidental or consequential damage result-
ing from any malfunction.

We are not responsible for any damage received from the use of water softeners, chemicals, de-scale mate-
rial or plastic wrap.

We are not responsible for the cost of service calls to diagnose the cause of trouble, or labor charge to 
repair and/or replace parts.

Contact the Dealer where you purchased the evaporative cooler.  If for any reason you are not satisfi ed 
with the response from the dealer, contact the Customer Service Department:  Champion Cooler, 5800 
Murray Street, Little Rock, Arkansas 72209.  1-800-643-8341.  info@championcooler.com

The evaporative media should be cleaned twice a season or when 
needed.  To clean the media, rinse with clean water.  Light scrubbing 
might be necessary.  Be careful not to damage media.  After about 
2 years, or when it becomes clogged, the media will need to be re-
placed.  To remove the media you will need to remove the plastic disk 
from the stem.  Push the keeper stem through the keeper disk until 
you can grab the disk to remove it.  Refer to fi g. 5.  

When replacing the evaporative media, install it so that the steeper 
fl ute angle of the media is sloping down towards the media frame (see 
fi g. 4).  Push the keeper stems through the media from the back of the 
media frame and press the keeper disks onto the stems to secure the 
media in place.

On occasion you may need to clean or replace the pump.  To remove the 
pump you will need to remove it from its base.  Unlock the pump from the 
base by twisting the pump counterclock-wise.  Lift the pump up out away 
from the base.  See fi gure 6.  Make sure there is no debris in the pump 
or hose.  Clean the base to make sure the openings are not blocked.  To 
remove the pump completely from the unit, disconnect the cord from the 
in-line connector.  Replace pump in opposite order.  Press the pump into 
the base and rotate it clockwise to lock it in place.  Ensure pump base is 
securely attached to cooler.

45°

15°

Keeper 

Disk

Keeper 

Stem

Fig. 5

3

Fig. 6

Twist To Unlock