Phantom Tech VI0508 사용자 설명서

Adjusting the

Latch

and

Tension Wires

Top Rail

Catch Frame

Latch

Door Frame

Push up the top of the

Catch Frame all the way

into the Top Rail

Adjusting the Latch

Pull the Sliding Bar over to the Catch Frame and
ensure that the Latch can be engaged. If the Latch
cannot be engaged, adjust it by following the
procedure shown in the diagram. Loosen the
screw, adjust the height of the Latch until it
engages with the Sliding Bar. Tighten the screw,
careful not to over tighten.

Adjusting the Tension Wires

1. Slide the Sliding Bar to the opposite end to

engage the Latch. Push the entire mesh over

to the Sliding Bar so that only the Tension

Wires are visible in the opening of the door.

Loosen the screw of the top most Tension Wire

Adjuster. Slide it up or down until snug, without

any sag in the Tension Wire. Tighten the screw

to secure it.

NOTE: do not over tighten the tension on the

Tension Wire.

2. If any of the other Tension Wires are sagging,

perform the same procedure with each adjuster.

If any of the situations below occur, follow the

appropriate procedure to correct the situation.

After adjusting the tension, move the Sliding Bar

two or three times to check the operation of the

Viewpoint Screen.

Loosen the screw
to move up and down.

Tension Wire

Adjuster

Screw

Keep the topmost Tension
Wire Adjuster fixed, loosen
the remaining Adjusters.
Starting from the bottom
Adjuster, adjust the tension of
each wire to remove the gap
as well as any sag in the
Tension Wires.

To correct this situation,
reverse the steps in
Situation #1 starting from
the top Adjuster.

Tighten the tension of the
loose Tension Wire to the
same tension as the other
Tension Wires.

Solution #3

Situation #1

Situation #2

Situation #3

Solution #2

Solution #1

Gap

Loose Tension Wire