Monte Carlo Fan Company 5STR52 사용자 설명서

Tighten both yoke set screws to further secure down-

rod. 

Install cotter pin into cross pin to secure.

Align holes in downrod and holes in yoke and install

cross pin.

Loosen the 2 yoke screws. 

Make wire connections as per above diagram.

Connect the white wire from the fan to the

White or Neutral wire from the power source.

Connect the black wire from the fan to the

Black or hot wire from the power source.

Connect all Green / Yellow wires from the fan,

Downrod and mounting bracket to the Ground

wire from the house.  

For Canadian installation in both flush and

downrod mode the safety cable must be

installed into the house structure beams using

the 3” lag screws provided.  Make sure that

when the safety cable is fully extended the

leadwires are longer than the cable and no

stress is placed on the leadwires.

CCaannaaddiiaann m

moouunnttiinngg oonnllyy

Make wire connections to power source using

wire nuts provided.  Make sure that no filiments

are outside of the wirenut. After making the

wire connections, the wires should be spread

apart with the grounded conductor and the

equipment-grounding conductor on one side of

the outlet box and ungrounded conductor on

the other side of the outlet box.

House

Fan

Black

White

Green

Black

White

Green(downrod)
Green(Bracket)

When alligned push screw in glass into the slotted

arm from light kit.

force the fitter arms. Align the 3 sloted arms with

the 3 screws in glass.

Plug in the 3 light bulbs by aligning the 2

prongs on bulb with holes in socket and then

push in and twist the 50 watt bulbs which are

GU10.

blades.Carefully lift fan assembly by fan body onto

mounting bracket. Rotate fan so that the notch on the ball

engages the ridge in the mounting bracket. This will allow

hands-free wiring. 

PEFORM FOR LIGHT KIT IF USED

Thread wires and safety cable from fan

through yoke cover, canopy and downrod.

downrod

canopy

yoke cover