Monte Carlo Fan Company 5RDR 사용자 설명서

Lift Canopy to ceiling aligning the key hole slots

with the screws on the bottom of the Mounting

bracket.  Rotate the canopy Counter Clockwise

to lock in place.  Tighten the screws to secure

the Canopy.  See inset for Keyhole shape

Attach blade brackets to blades using

the blade bracket screws and wash-

ers provided.

Install all 5 fan blade assemblies to

the motor as shown above.  Tighten

screws securely.  

For Canadian installation in both flush and

downrod mode the safety cable must be

installed into the house structure beams using

the 3” lag screws provided.  Make sure that

when the safety cable is fully extended the

leadwires are longer than the cable and no

stress is placed on the leadwires.

Canadian mounting only

Make wire connections to power source using

wire nuts provided.  Make sure that no filiments

are outside of the wirenut. After making the

wire connections, the wires should be spread

apart with the grounded conductor and the

equipment-grounding conductor on one side of

the outlet box and ungrounded conductor on

the other side of the outlet box.

white

black

Make wiring connections as indicated above.

White from fan to white from remote marked

N.  Orange from fan to Orange from remote

marked Light/up. Blue from fan to blue from

remote marked down light. Black from fan to

Black from remote marked L.  White from

house to white from remote marked AC N .

Black from house to Black from remote

marked AC  L. Connect all green ground wires

to Ground wire from House.

orange

blue

Green

white
black

House

Fan

Loosen 2 screws and remove one

and save it. Place plate’s key slotted

holes over the 2 screws loosened and

twist into place. Replace removed

screws and tighten all 3.

Attach switch housing to fan using

the three screws provided.  

Plug 9 pin wire connections together. 

Remove cover by snaping off from

top or bottom. Install 12V battery

into wall remote. Duracell MN21 /

Eveready A23 / GP 23A all 12V.

Install wall control unit to outlet box

using machine screws provided.

Attach cover of remote by placing

over buttons and snaping into place.