Casablanca Fan Company Bellatm Bella Ceiling Fan 사용자 설명서
3
INSTALLATION INSTRUCTIONS
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them
against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
PERMA•LOCK™ HARDWARE
NOTE: If this is the second Versa•Touch fan installed in the same
area, one of the fans MUST have its channel changed. Please refer
to the Versa•Touch section on the bottom of page 9.
area, one of the fans MUST have its channel changed. Please refer
to the Versa•Touch section on the bottom of page 9.
Setup. Remove the bottom foam from the box
and place the fan rightside up in the foam. This
protects the lamp socket during assembly.
and place the fan rightside up in the foam. This
protects the lamp socket during assembly.
WORK BENCH SETUP
FOAM
WORK BENCH
B
ELLA
™
FAN PREPARATION
Prepare for fan installation as follows:
Step B. Using the provided allen wrench, loosen the set screw
several turns to allow installation of the downrod. Thread
the downrod into the motor coupling until it stops turning,
this will take at least four and a half full turns.
several turns to allow installation of the downrod. Thread
the downrod into the motor coupling until it stops turning,
this will take at least four and a half full turns.
Step C. Securely tighten the set screw with the provided allen
wrench to ensure safe operation of your fan.
wrench to ensure safe operation of your fan.
Step A. Place the downrod through the motor cover as shown.
Route the wires from the fan motor through the Perma•Lock™
Route the wires from the fan motor through the Perma•Lock™
downrod and ball assembly.
CAUTION: Failure to fully lock in the down-
rod before securely tightening the allen set
screw may cause the fan to separate from
the downrod during normal operation!
rod before securely tightening the allen set
screw may cause the fan to separate from
the downrod during normal operation!
IMPORTANT SAFETY INFORMATION!
BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN, INSTALL THE
THREADED DOWNROD INTO THE MOTOR COUPLING AND LOCK THE ASSEMBLY
DOWNROD & BALL
ASSEMBLY
ALLEN SET SCREW
1
⁄
4
-20 x
1
⁄
4
"
(PRE-INSTALLED)
3mm
ALLEN WRENCH
TAPERED
THREAD
MOTOR
WIRES
GROUND
WIRE
ALLEN
SET SCREW
DOWNROD
& BALL
ASSEMBLY
MOTOR
COVER
Tip: The downrod has a tapered thread
that is designed to lock completely when
correctly installed.
that is designed to lock completely when
correctly installed.
ATTACH MOTOR COVER
Step D. Using the three screws provided, attach the motor
cover to the motor. Tighten firmly by hand only.
cover to the motor. Tighten firmly by hand only.
MOTOR COVER
SCREWS (3)
NOTE: The fan weight is 30 pounds.