Casablanca Fan Company 4726D 사용자 설명서

After turning the power OFF at its source (either the circuit 
breaker or fuse box), lower the old fi xture and disconnect 
the wiring. Check the ceiling fi xture outlet box to be sure 
it is marked “Approved for Ceiling Fan Mounting.” If it is 
not, a new box must be installed. 

If you do not have an existing fi xture located where you 
wish to place your Casablanca fan, an approved ceiling 
fi xture outlet box must be installed and wired. 

NOTE: The weight of this fan is 25 pounds.

WARNING!

To  reduce  the  risk  of  fi re, electrical shock, or 
personal injury, mount to outlet box marked 
“Acceptable Fan Support of 22.7 kg (50 lbs.) or 
less” using the mounting hardware provided with 
the outlet box.

Step 1a. Remove the knockout plug in the center of the 
outlet box or drill a ½" hole for the lag screw to pass 
through. Then drill a ¼" guide hole into the joist or beam 
to a depth of 3 inches. 

Step 1b. Route the outlet box wires through the keyhole 
slot of the crossbar mounting bracket as shown. Attach 
the crossbar mounting bracket to the outlet box with the 
screws provided, making sure the outlet box wires are not 
pinched by the washer. 

CAUTION: 

To reduce the risk of personal injury, use only the 
mounting hardware provided with the approved 
outlet box to install the crossbar mounting 
bracket.

CEILING HARDWARE (not to scale)

NOTE: After removing the old fi xture, check the outlet box 
to insure that it is supported by a joist or beam across its 
upper surface. If not, a 2 x 4 stud must be installed.

WARNING!

Support directly to building structure only.