Vermont Casting MEAD3BS 사용자 설명서

4

Models: CAPCB, CAPEB

Read these instructions before beginning the instal-
lation.
CAUTION: Always place castings on a flat protected 
work surface, such as a towel, blanket or carpet.
These instructions are for the assembly and installation 
of the Small Cast Profile Surround to the Montpelier 
Insert.
Carefully unpack and inspect all components from the 
shipping box. Report any missing or damaged parts to 
your dealer immediately. Install trim kit after all other 
insert installation work has been completed, thoroughly 
checked and tested for proper operation, leaks and 
installation requirements.
Tools required: Tape measure.
Surround Parts
Column Right Assembly 
  Column, right
  Boot, right
  Slider clip, right
  Bracket, On/Off switch (not used on Montpelier Insert)
  1/4-20 Round head screw (2)
  1/4-20 Wing screw (2) 
  1/4 Flat washer (3)
Column Left Assembly
  Column, left
  Boot, left
  Slider clip, left
  1/4-20 Round head screw
  1/4-20 Wing screw (2)
  1/4 Flat washer (3)
Key
Upper mounting bracket
Upper mounting bracket R 

(not used on Montpelier Insert)

Hardware Bag
  1/4-20 Wing Screw (5)
  1/4 Flat washer (5)

1.  Place the key on your work surface with the thread-

ed holes facing up.

2.  Place the column right assembly onto the key. (Fig. 

4)

3.  Place the column left assembly onto key. (Fig. 5)

KT424

column right

assy

9/03

Key

Column Right 
Assembly

KT424

Fig. 4  Place column right assembly onto key.

KT425

column left

assy

9/03

Key

Column Left 
Assembly

KT425

Fig. 5  Place column left assembly onto key.

4.  Install the upper mounting bracket. Use the upper 

mounting without the marked “R” stamped on the 
face. (Fig. 6)

5.  Fasten the upper mounting bracket to the key with 

a 1/4-20 wing screw and 1/4 flat washer finger tight. 
(Fig. 6)