Amana *M(H 사용자 설명서

34

1. Shut off electric power and gas supply to the furnace.
2. Disconnect the rollout limit wires, flame sensor wire, and

disconnect the igniter plug.

3. Remove four (4) screws securing the burner box top.

4. Remove the screws securing the burners to the burner

bracket. Remove the burners.

5. Use bottle brush to clean burner insert and inside of

burner.

6. Replace burner (opposite of removal).  Ensure burners

are fully seated on burner bracket and are properly
aligned.  Replace burner box top. Reconnect wiring.

7. Turn on electric power and gas supply to the furnace.
8. Check furnace for proper operation.  Refer to “Operational

Checks” section  to verify burner flame characteristics.

•

Cycle the furnace with the thermostat at least three
times.  Verify cooling and fan only operation.

•

Review the Owner’s Manual with the homeowner and
discuss proper furnace operation and maintenance.

•

Leave literature packet near furnace.

•

When ordering any of the listed functional parts, be sure
to provide the furnace model, manufacturing, and serial
numbers with the order.

•

Although only functional parts are shown in the parts
list, all sheet metal parts, doors, etc. may be ordered by
description.

•

Parts are available from your distributor.

Functional Parts List-

Gas Valve

Blower/Collector Box Gasket

Natural Gas Orifice

Primary Limit Switch

Propane Gas Orifice

Rollout Limit Switch

Burner

Auxiliary Limit Switch

Hot Surface Igniter

Heat Exchanger

Flame Sensor

Door Switch

Gas Manifold

Transformer

Ignition Control

Blower Wheel

Blower Mounting Bracket

Blower Housing

Pressure Switch

Blower Cutoff

Pressure Switch Hose

Blower Motor

Induced Draft Blower

Motor Mount Bracket

Collector Box

Capacitor