Precisionaire Cell GT 전단
Nominal
Nominal
250 fpm
375 fpm
500 fpm
625 fpm
Media
Weight
Depth
Efficiency
Size
Area
Each
(inch)
HxWxD
cfm
pd
cfm
pd
cfm
pd
cfm
pd
(sq.ft.)
(lbs.)
(inch)
24x24x12
1000
1500
2000
2500
140
26
12
65%
.20
.35
.45
.57
24x12x12
500
750
1000
1250
69
14
24x24x12
1000
1500
2000
2500
140
27
12
95%
.25
.45
.65
.78
24x12x12
500
750
100
1250
69
14
Notes:
1. PD represents clean pressure drop in inchw.g. The recommended final pressure drop is 1.5 inch w.g.
2. Operation down to zero velocity is satisfactory for all models.
3. Performance tolerances conform to section 7.4 of ARI Standard 850.
4. Performance values stated may be averages typical of the products listed. Contact factory for actual performance
2. Operation down to zero velocity is satisfactory for all models.
3. Performance tolerances conform to section 7.4 of ARI Standard 850.
4. Performance values stated may be averages typical of the products listed. Contact factory for actual performance
test reports on specific products.
5. Perfmormance values shown in this publication may be averages or estimates intended to generally represent
product styles. Always contact factory for latest actual test data on specific Flanders Precisionaire models.
1.0 General
1.1 Medium and high efficiency gas turbine rigid fil-
ters shall be PrecisionCell GT extended media
separator type filters as manufactured by
Flanders.
separator type filters as manufactured by
Flanders.
1.2 Filter sizes, efficiencies and capacities shall be
as scheduled on the drawings.
2.0 Filter Construction
2.1 Filters shall be constructed by pleating a con-
tinuous sheet of moisture-resistant dual layer,
wet-laid micro-fine glass media into closely
spaced pleats with hemmed-edge corrugated
aluminum separators.
wet-laid micro-fine glass media into closely
spaced pleats with hemmed-edge corrugated
aluminum separators.
2.2 The filter pack shall be compression sealed into
a 24 ga. corrosion-resistant steel frame.
2.3 The enclosing frame shall be assembled in a
rigid manner and shall incorporate a single or
double header as required by job conditions.
double header as required by job conditions.
2.4 Corrosion-resistant steel expanded metal face-
guards shall be installed on the air entering and
leaving sides.
leaving sides.
2.5 1/2” corrosion-resistant steel “T” straps shall be
installed on the air leaving side and horizontal
strap on air entering side.
strap on air entering side.
2.6 Filters shall be UL 900 Class 1 listed.
3.0 Performance
3.1 Initial and final resistance shall not exceed the
scheduled values.
3.2 Media area must equal or exceed that of the
specified filter.
3.3 The average efficiency shall be as determined
by the ASHRAE Standard 52.1 and 52.2 test
methods.
methods.
3.4 The manufacturer shall guarantee performance
as stated in the literature within tolerances as
outlined in section 7.4 of ARI Standard 800.
outlined in section 7.4 of ARI Standard 800.
Guide Specifications
REPRESENTED BY:
Flanders PrecisionAire
Foremost in Air Filtration
Toll Free: 1-800-637-2803