Chamberlain 3575CS 사용자 설명서

27

Press the push bar to 
open or close the 
door. Press again to 
reverse the door 
during the closing 
cycle or to stop the 
door while it's 
opening.

This door control 
contains a motion 
sensing detector that 
will automatically turn 
on the light when it 
detects a person entering the garage.

Press the Light button to turn the opener light on 

or off. It will not control the opener lights when the door is 
in motion. If you turn it on and then activate the opener, the 
light will remain on for 4-1/2 minutes. Press again to turn it 
off sooner. The 4-1/2 minute interval can be changed to 
1-1/2, 2-1/2, or 3-1/2 minutes as follows: Press and hold 
the Lock button until the light blinks (about 10 seconds). A 
single blink indicates that the timer is reset to 1-1/2 
minutes. Repeat the procedure and the light will blink 
twice, resetting the timer to 2-1/2 minutes. Repeat again 
for a 3-1/2 minute interval, etc., up to a maximum of four 
blinks and 4-1/2 minutes.

When using the opener lights as working lights, we 
recommend that you first disable the motion sensor. See 
Automatic Light Feature, below.

Motion Sensing (Automatic Light Feature): The opener 
light will turn on automatically when a person enters the 
garage. When a person walks in front of the door control, 
the light will come on for five minutes, then shut off. This 
feature works by detecting body heat.

To disable this feature, push the motion sensing 
button on the side of the door control.

We recommend that you disable the motion 

sensor when using the opener lights as working lights. 
Otherwise, they will turn off automatically if you are 
working beyond the sensors range.

Designed to prevent operation of the door from 

hand-held remote controls. However, the door will open 
and close from the Door Control, the Outdoor Key Switch 
and the Keyless Entry Accessories.

 To activate, press and hold the Lock button for 2 seconds.

To turn off, press and hold the Lock button again for 
2 seconds. The Lock feature will also turn off whenever the 
“learn” button on the motor unit panel is activated.

Motion Sensing

On/Off

Prog <Learn>

Hour

Minute

Language

Degrees (F/C)

Lock Button

Light
Button

Push
Bar

LOCK

LIGHT

The door control is equipped with a PROG <LEARN> 
button to assist in learning remote controls to the unit. 
Press the PROG <LEARN> button once to initiate LEARN 
mode and the display will show ‘Learn Remote Control - 
Press Learn Button Again to Confirm’. Press the PROG 
<LEARN> button a second time and the display will show 
‘Learn Mode - Press Remote Control Button to Learn 
Remote.’ Press the button of the remote control to be 
learned and the worklight will blink to confirm the remote 
control has been learned.

Hour & Minute Feature
Press or hold either of these side buttons to 

increment the hour or minute displayed on the LCD 
display.

Press this side button to toggle between the three 
languages - English, French and Spanish.

Press this side button to toggle the temperature 
units between Fahrenheit and Celsius.

Press and hold the light button then push the hour button 
to increase the contrast or the minute button to decrease 
the contrast.

LIGHT

LOCK

H

M