Chamberlain 1150-1/3HP 사용자 설명서

다운로드
페이지 28
Radio Controls
F.C.C. rules prohibit adjustments to or modification of
receiver and/or remote control transmitter circuitry
except for changing 
code setting and replacing remote
control transmitter battery. NO USER SERVICEABLE
PARTS.
Manufactured under 1 or more of the following U.S. patents: RE29,525;
 4,750,118; 4,8e8,930. Other Patents Pending.
ACTIVATE THE OPENER ONLY WHEN
DOOR IS IN FULL VIEW, FREE OF
OBSTRUCTION AND PROPERLY
ADJUSTED. NO ONE SHOULD ENTER OR LEAVE
GARAGE WHILE DOOR IS IN MOTION. DO NOT
ALLOW CHILDREN TO OPERATE REMOTES OR
DOOR CONTROL BUTTONS. DO NOT ALLOW
CHILDREN TO  PLAY  NEAR THE DOOR
.
Your garage door opener receiver and remote control transmitter have been factory set to a matching code. If you
want to CHANGE your code or purchase additional remotes, follow the Instructions below. The code in any NEW remote
control must be set to match the code in the original remote control.
MATCH/CHANGE THE CODE IN REMOTE CONTROL(S)
1. Slide battery compartment cover back to access code switches in your single function remote and any new remote
    control.
2. Place remotes side by side as shown and set switches in ALL remotes to matching positions (+, -, 0). Use a pen or
    screwdriver to slide the code switches.
NOTE: Instructions for matching the code switches in two-channel and multi-function remote control
transmitters are Included with those accessories.
MATCH/CHANGE THE CODE IN THE RECEIVER
GARAGE DOOR OPENERS
WITH RECEIVER "SMART" CODE BUTTON
3. Press the RECEIVER Smart Button on the  back panel
of the opener as shown. The adjacent indicator light
will turn ON.
CAUTION:  Door will begin to move Immediately If any
transmitter has been activated.
If this occurs, wait until the door has completed Its UP
or DOWN cycle. Then begin again at Step 3.
4. STAND AWAY FROM THE  DOOR and press the
remote control transmitter push button. The indicator
light will turn OFF and  the door will move. Receiver
and remote control(s) codes now match. The  opener
will operate when either the door control button or the
remote control transmitter push button is pressed.
NOTE: If the remote control transmitter push button is
not pressed within 30 seconds, the indicator light will
turn OFF. In that case, begin again at steps 3.
23