Vermont Casting TBREF36 사용자 설명서

8

1.  Locate the switch under the logset on the left front 

corner of the unit.

2.  Check the voltage selection switch position to ensure 

it is in the 120 Volt position.

3.  Loosen the screws securing the junction box cover 

and remove the cover.

4.  Remove knockouts in the box cover to use the cable 

clamp.

5.  Pull out two (2) wires:  black and white.
6.  Connect the black wire from the unit to the L1 (black) 

from the power supply. Connect the white wire from 
the unit to the neutral (white) from the power supply. 

7.  Connect the ground wire from the power supply to 

ground stud in the junction box.

8.  Make sure the red wire (L2) in the junction box has a 

closed end splice or a wire nut properly applied.

9.  When the unit has been configured for the appropri-

ate power supply voltage, ensure all connections 
are tight. Insert all wiring inside the junction box and 
secure the cover.

10. Turn the power to the unit on at the breaker/fuse 

panel. Place the unit into operation and check to 
make sure the whole system is operating properly.

1.  Loosen the screws securing the junction box cover 

and remove the cover.

2.  Remove knockouts in the box cover to use the cable 

clamp.

3.  Pull out two (2) wires: black  and white.
4.  Connect the black wire from the unit to the L1 (black) 

from the power supply. Connect the white wire form 
the unit to the neutral (white) form the power supply.

5.  Connect the ground wire from the power supply to 

the ground stud in the junction box.

6.  Ensure all connections are tight. Insert all wiring 

inside the junction box and secure the cover.

7.  Turn the power to the unit on at the breaker/fuse 

panel. Place the unit  into operation and check  to 
make sure the system is operating properly.

1.  Locate the voltage selection switch under the logset 

on the left front corner of the unit.

2.  Check the switch position to ensure it is in the  

240 Volt position.

3.  Loosen the screws securing the junction box cover 

and remove the cover.

4.  Remove knockouts in the box cover to use the cable 

clamp.

manually reset. 
The safety limit device is located in a cutout at the right 

front top corner by the cover fan/ heater. To reset the 

switch, insert a small flat screwdriver into this cutout 

and push the reset button on the safety limit device.

5.  Pull out three (3) wires:  black, red, and white.
6.  The unit is shipped from factory with a closed end 

splice on the red wire. Cut off this splice and strip 
approximately 5/8" (15mm) wire sheathing.

7.  Connect the black wire from the unit to the L1 

(black) from the power supply. Connect the red wire 
from the unit to the L2 (red) from the power supply. 
Connect the white wire from the unit to the neutral 
(white) from the power supply. 

8.  Connect the ground wire from the power supply to 

ground stud in the junction box.

9.  When the unit has been configured for the appropri-

ate power supply voltage, ensure all connections 
are tight. Insert all wiring inside the junction box and 
secure the cover.

10. Turn the power to the unit on at the breaker/fuse 

panel. Place the unit into operation and check to 
make sure the whole system is operating properly.

FP1452

Safety limit switch

2/25/04  djt

Safety Limit Device

Small Flat Screwdriver

Cover Fan/

Heater

FP1452

Fig. 4  Reset the switch with a small flat screwdriver.