Regency P40-NG1 사용자 설명서

Regency

P40-1 Direct Vent Gas Fireplace

INST

ALLA

TION

INSTALLATION

VENTING ARRANGEMENTS

HORIZONTAL TERMINATION (FLEX)

Regency

Direct Vent System

These venting systems, in combination with the P40 Direct Vent Gas Fireplace, have been tested and listed as a direct vent heater system by
Warnock Hersey. The location of the termination cap must conform to the requirements in the Vent Terminal Locations diagram in "Exterior Vent
Termination Requirements" section.

Regency

Direct Vent (Flex) System

Termination Kit (Part# 946-618) includes all
the parts needed to install the P40 with a
maximum run of 6 feet.

1) 8" dia. fl exible liner (6 ft. length)
2) 5" dia. fl exible liner (6 ft. length)
3)  spring spacers (4)
4) thimble
5)  AstroCap XL termination cap (1)
6) screws (12)
7)  tube of Mill Pac (1)
8)  plated screws (8)
9)  screws #8 x 1-1/2" Drill Point,

Stainless Steel (4)

10) vinyl siding standoff

If longer runs are needed, the Regency

Direct

Vent system (Flex) Part# 946-616 includes
all the parts needed to install the P40 with a
maximum 10' run.

1) 8" dia. fl exible liner (10 ft. length)
2) 5" dia. fl exible liner (10 ft. length)
3)  spring spacers (7)
4) thimble (2)
5)  AstroCap XL termination cap (1)
6) screws (12)
7)  tube of Mill Pac (1)
8)  plated screws (8)
9)  screws #8 x 1-1/2" Drill Point,

Stainless Steel (4)

10) vinyl siding standoff

Notes:

1) Liner sections should be continuous without any joints or seams.

2) Only Flex pipe purchased from FPI may be used for Flex installations.

3) Horizontal vent must be supported every 3 feet. (For 10' fl ex kit 946-616 only.)

8" dia.

Flue pipe

5” dia. flue pipe

spring spacer

(Part# 946-623/P)

AstroCap XL

Wall Thimble

(required in Canada only)

Vinyl Siding

Standoff