Regency P40-NG1 사용자 설명서

Regency

®

 P40-1 Direct Vent Gas Fireplace

MAINTENANCE

Your Regency

®

 fi replace is supplied with high 

temperature 5mm-Ceramic glass. If your glass 
requires cleaning, we recommend using an 
approved glass cleaner available at all authorized 
dealers. Do not use abrasive materials.

*   Do not clean when the glass is hot.
*  The use of substitute glass will void all product 

warranties.

*  Care must be taken to avoid breakage of the 

glass.

*   Do not strike or abuse the glass.
*  Do not operate this fi replace without the 

glass front or with a cracked or broken glass 
front.

*  Wear gloves when removing damaged or 

broken glass.

*  Replacement of the glass panel(s) should be 

done by a licensed or qualifi ed service per 
son.

In the event that you break your glass by impact, 
purchase your replacement from an authorized 
Regency

®

 dealer only.

Replacement glass is shipped already installed 
into the door frame. Reinstall as per Glass Door 
Installation in "Standard Flush Door" section.

1)  Unplug the power source.

2)  Remove the power module by lifting it up 

off of the velcro and pull out.

3)  Undo the wire holder by releasing tab.

4)  Remove the Control module by lifting it up 

and off to the side.

5)  Unplug the J1, J2 and J3 harness at the ECS 

module and pull out the Control module.

6)  Remove the fan ground wires.

7)  Disconnect the brown and blue wires 

connected to the J1 harness.

8)  Release the 2 wire tabs.

9)  Remove both fans by lifting up off of the 

pins and tilt sideways and then slide to the 
left of the fi rebox and pull out carefully.

10) Reverse steps to re-install.

NOTE:  To facilitate easier re-installation of the 
fans, apply some lubricante to the rubber grom-
mets at the base of the fan bracket.