Regency U32-NG4 사용자 설명서

U32-4 FPI Direct Vent Gas Insert

If your fan requires maintenance or replacement, 
access to the fan is through the plate on the rear 
wall of the fi rebox. NOTE: the unit MUST NOT 
be operated without the fan access panel 
securely in place.

1)  Remove the door from the unit and place 

on a soft surface to prevent scratching.

2)  Remove the nuts holding the glass retainers 

in place.

3)  Remove the glass retainers (sides, top and 

bottom).

4) Replace 

the 

glass. 

5)  Reverse the previous steps, replace the 

retainers and fasten with the nuts but do not 
over tighten, as this can break the glass.

6)  Replace door on the stove and check the 

seal. 

7)  Remove the 2 screws holding the Air Intake 

Hood to the rear fi rebox wall and lift out.

8)  Remove the 10 screws holding the Access 

Panel in place.

9)  Remove the Fan Air Duct by loosening the 

3 screws, squeeze the sides together to 
remove.

1)  Turn the unit off and allow it to cool to room 

temperature.

2)  Unplug or disconnect power source to 

stove.

3)  Remove glass front (see section "Standard 

Flush Door.")

4)  Remove logs and brick panels, if used.

5)  Remove the grate by loosening the two 

screws and sliding the grate out.

6)  Remove the burner/front log support 

assembly by  removing the 2 screws and 
lifting it out.

Reverse above steps. Hint for pushing fan down 
onto pins - rub a bit of dish soap on the grommet 
so it will slide more easily onto the pin. 

Check to make sure the fan is seated properly 
on the pins,  this is very important-  try to move 
the fan back and forth, there should be no noise, 
if there is check that the grommets haven't 
come loose.

Seal fan access panel using high temperature 
silicone (sparingly).

10) Unplug the wires from the fan motor (from 

inside the stove).

11)  Lift Fan Assembly off of the 2 pins, tip forward 

and pull through fi rebox opening.

12) Disconnect green wire from power cord.