Enviro EG40-070 사용자 설명서

다운로드
페이지 36
support straps to the roof. Seal the nails holes heads with non-hardening mastic. Trim the excess 
length of the support straps that extend out beyond the edge of the flashing.
7.  Slip the flashing over the pipe section protruding through the roof. Secure the base of the flashing to 
the roof with roofing nails. Use a non-hardening sealant between the uphill edge of the flashing and 
the roof. Insure the roofing material overlaps the top edge of the flashing as shown in Figure 30. Verify 
that you have at least the minimum clearance to combustibles at the roof line.
8.  Continue to add pipe sections until the height of the vent cap meets the minimum code requirements. 
Refer to Figure 31 and Table 5. Note that for steep roof pitches, the vent height must be increased. In 
high wind conditions, nearby trees, adjoining roof lines, steep pitched roofs, and other similar factors 
can result in poor draft, or down drafting. In these cases, increasing the vent height may solve the 
problem.
9.  Slip the storm collar over the pipe, and push it down to the top of the roof flashing as shown in Figure 
Table 5: Minimum ‘H’ for Figure 31.
Roof Pitch
Minimum Height
Ft
Meters
Flat to 7/8
1
0.3
Over 7/12 to 8/12
1.5
0.46
Over 8/12 to 9/12
2
0.61
Over 9/12 to 10/12
2.5
0.76
Over 10/12 to 11/12
3.25
0.99
Over 11/12 to 12/12
4
1.22
Over 12/12 to 14/12
5
1.52
Over 14/12 to 16/12
6
1.83
Over 16/12 to 18/12
7
2.13
Over 18/12 to 20/12
7.5
2.29
Over 20/12 to 21/12
8
2.44
Figure 31: Height of Vertical Termination; 
Reference Table 5. 
23
Initial Installation
QUALIFIED INSTALLERS ONLY
Figure 32: Use of Wall Straps.
30. Use the non-hardening sealant around the 
joint between the pipe and the storm collar.
10. Twist-lock the vent cap.
NOTES: 
•  
If an offset is necessary in the attic to avoid obstructions, 
it  is  important  to  support  the  vent  pipe  every  3  ft  (91 
cm), to avoid excessive stress on the elbows, and possible 
separation. Wall straps are available for this purpose (see 
Figure 32).
•  When  ever  possible,  use  45°  degree  elbows  instead  of 
90°  degree  elbows.  The  45°  degree  elbow  offers  less 
restriction to the flow of flue gases and intake air.