Vermont Casting 2477CE 사용자 설명서

11

Your convection heater requires some assembly.  
Follow the directions carefully and refer to the parts 
diagram at the back of this manual.

Remove the bottom heat shield strapped to the top of 
the stove and all loose parts from the firebox and the 
ash pan. Check to make sure all the parts are included 
and intact. You should have received:

• 

1 fully assembled heater body

• 

1 bottom heat shield*

• 

4  legs

• 

1 ash pan

• 

1 ceramic handle assembly

• 

1 hardware bag, containing the following parts:

• 

(3) #10 x 1/2” sheet metal screws,  (to attach the 
chimney connector to the flue collar)

• 

(1) 3 mm (1/8”) Allen wrench, (to tighten the door 
latch) 

• 

(1) 4 mm (5/32”) Allen wrench, (to tighten the 
damper handle)

• 

(4) washers, (used with the leg bolts to attach 
legs to the stove)   

• 

(1) door handle insert holder (for storing the ce-
ramic handle assembly when it is not in use.)

• 

(4) 1/4-20 x 1” hex  head screws, (to attach legs)

If any parts are missing or damaged, immediately notify 
your Dutchwest dealer for replacements. Do not install 
your stove without having all necessary parts or using 
damaged parts.
* A Bottom Heat Shield is required in many instal-
lations. Refer to the floor protection information 
found in the Installation Section of this manual. 

NOTE:  To avoid damaging the sheet metal compo-
nents, do not place the stove on its back to install the 
legs. Follow the instructions below.
1.  Remove the band that holds the stove to the pallet 

and remove the bottom heat shield that was posi-
tioned on top of the stove. (Fig. 15)

2.  Rotate the stove counterclockwise until the front left 

corner overhangs the pallet and the leg-mounting 
hole is accessible. (Fig. 16)

3.  Remove and discard the (4) 1/4-20 x 3/8” hex head 

bolts that are in the leg holes on the bottom of the 
stove.

 
 

4.  In the hardware bag, locate the four legs, the door 

handle insert holder, (on this leg only, the door 
handle insert holder is used along with a washer), 
(4) 1/4-20 x 1” leg bolts and four (4) washers. 

5.  Place the bolt through a washer and then the door 

handle insert holder and align the leg with the bolt 
hole in the bottom of the stove. Tighten securely. 

ST813

stove on pallet

6/04

Bottom Heat Shield

ST813

Fig. 15  Remove bands holding stove to pallet and remove 
heat shield from to of stove.

ST814

front left leg

6/04

Leg 

Bolt

Handle Insert 

Holder

ST814

Fig. 16  Rotate stove on pallet to expose front left corner.