Enviro EG-40 사용자 설명서

 
 
 
 

A= Clearance above grade, verandah, porch, deck, or 
 

[balcony (*12 inches (30 cm) minimum] 

B= Clearance to window or door that may be opened 
 

[*12 inches (30 cm) minimum] 

C= Clearance to permanently closed window 
 

[minimum 12 inches (30 cm) recommended to 

 

prevent condensation on window] 

D= Vertical clearance to ventilated soffit located  above 
the terminal within a horizontal   distance of 2 feet (60 
cm) from the center-line  

of the terminal 24 

inches ( 60 cm) minimum 
E= Clearance to unventilated soffit  

[18 inches   (45 cm) minimum] 

F= Clearance to outside corner [12 inches minimum] 
G= Clearance to inside corner [`12 inches minimum] 

H= *Not to be installed above a meter/regulator 
 

assembly within 3 feet (90 cm) horizontally 

 

from the center-line of the regulator 

I= Clearance to service regulator vent outlet  

[*6 feet    (1.8m) minimum] 

J= Clearance to non-mechanical air supply inlet to 
 

building or the combustion air inlet to any 

 

other appliance [12 inches (30 cm) minimum] 

K= Clearance to a mechanical air supply inlet  

[*6 feet (1.8m) minimum] 

L= *** Clearance above paved side-walk or paved 
 

driveway located on public property  
[*7 feet     (2.1m) minimum] 

M= Clearance under verandah, porch, deck, or   balcony 
 

[*24 inches (60 cm) minimum **] 

 

*** A vent shall not terminate directly above a sidewalk or paved driveway, which is located between two single-
family dwellings and serves both dwellings.  
** Only permitted if verandah, porch, deck, or balcony, is fully open on a minimum of 2 sides beneath the floor 
•  As specified in CGA B149 Installation Codes (1991) Note: Local Codes or Regulations may require different 

clearances 

NOTE: THIS HEATER MUST BE PROPERLY CONNECTED TO A VENTING SYSTEM.  THIS HEATER IS 

EQUIPPED WITH A VENT SAFETY SHUTOFF SYSTEM DESIGNED TO PROTECT AGAINST IMPROPER 

VENTING OF COMBUSTION PRODUCTS.  

 

THIS SAFETY SWITCH IS LOCATED ON THE REAR OF THE APPLIANCE CLOSE TO THE DRAFT HOOD 

RELIEF OPENING. 

 

IF THE SWITCH TRIPS MORE THAN ONCE THE CHIMNEY SHOULD BE INSPECTED BY A QUALIFIED 

 SERVICE TECHNICIAN FOR POSSIBLE BLOCKAGE OR SEVERE DOWN DRAFT CONDITIONS 

 
This stove can be vented with aluminum or stainless steel flex vent and/or certified 4" Type B Gas Vent. The flue 
collar of the appliance will fit inside of a standard 4” vent and may be fastened directly to the vent. 
 
Check periodically that the vent is unrestricted and an adequate draft is present when the unit is in operation. 
 

WARNING: Operation of this heater when not connected to a properly installed and maintained venting system or 

tampering with the vent safety shutoff system can result in carbon monoxide (CO) poisoning and possible death. 

 

6