Mr. Heater MH12C 사용자 설명서

Operating Instructions and Owner’s Manual

Mr. Heater | Gas-Fired Infra-Red Portable Heater

HOOK-UP INFORMATION

1.1  Heater models MH12C and MH12CS are packaged completely 

assembled except for metal stand. Propane cylinders are not 
included with models MH12C and MH12CS.

1.2  Remove heater from carton.

1.3  Hold heater in one hand and with the other hand hold propane 

cylinder vertically and carefully turn clockwise into heater valve-
regulator until snug. (Careful not to cross-thread) – Fig. 1 and 
Fig. 2.

1.4  Use only LP-gas cylinders constructed for use with propane only 

(HD-5) and marked in accordance with the specifications for 
LP-gas cylinders of the U. S. Department of Transportation (DOT 
Spec. 39).

1.5  Use propane fuel cylinders of not more than 75 cubic inches 

(2-1/2 pounds nominal water capacity) and connect to cylinder 
valve outlet connection No. 600 as specified in the Compressed 
Gas Associations Limited Standard Cylinder Valve Outlet 
Connection for propane-small valve series.

2.1  Grasp heater model by cylinder and hold wire stand with other 

hand. Slide mounting clip on back of heater onto chrome plated 
wire stand. Fig. 1 and 2.

2.2  Push igniter lead onto end of Sparklite Igniter on Model 

MH12CS-Figure 2.

2.3  Make sure wire stand is on a flat surface in the outdoors. See 

paragraph 5 for additional assembly procedure.

2.4 

  Never touch heater while in operation to avoid injury. 

Move heater by grasping the propane cylinder carefully.

2.5  Read pages 3 and 4 before lighting heater.

Figure 1

Figure 2