Quadra-Fire GARNET-D-PMH 사용자 설명서

August 1, 2008

Page  25

Quadra-Fire · Garnet-T · 7016-127F

Before making gas connections ensure that the appliance 
being installed is compatible with the available gas type.

Any natural or propane gas conversions necessary to meet 
the appliance and locality needs must be made by a quali-
fi ed technician using Hearth & Home Technologies specifi ed 
and approved parts.

   Lift off the appliance top and place it on a flat sur-

face, with the porcelain side up to prevent damage. Remove 
the appliance front by sliding it upwards in the grooves, being 
careful not to chip the porcelain. Lay the appliance front face 
up on a flat surface.

Remove burner: First remove ONLY the two screws indi-
cated in. DO NOT remove the screws from the burner top. 
Lift the burner up and out of the fi rebox.

   Pull off pilot hood and set aside.  NOTE: Do not 

   Use a 5/32 in. Allen wrench to remove the pilot 

injector.  

Replace pilot injector with the appropriate size injector supplied 
with the appliance (#35 for Propane, #62 for Natural Gas).

Replace pilot hood, snapping into position. Be sure to align 
notch on left side of pilot hood.

   Remove main burner orifi ce using a 3/8 in. wrench. 

Replace orifi ce with the proper size as indicated below for 
your gas type and venting.

 #56 

#49 

Reinstall burner. 

TOOLS REQUIRED:  Power drill (a 90° drill is helpful); 
Slotted screwdriver or Torx TH20; #2 Phillips bit; 5/32" 
Allen wrench; 3/8" open end wrench.

Remove 2 screws

MILLIVOT GENERATOR

PILOT HOOD

THERMOCOUPLE

5/32 in. Allen 
wrench