Empire Comfort Systems BF-20-2 사용자 설명서

Page 8

16943-5-0806

  1.  Align  clearance  holes  on  floor  stand  with  screw  holes  on 

bottom of heater, as shown in Figure 5.

  2.  Attach floor stand to heater with (4) screws provided with 

floor stand.

  3.  Connect the gas line.

  *   SRS-18  floor  stand  can  not  be  used  in  a  bedroom 

installation.

    BF-10 must be wall mounted in a bedroom installation.
Installation on Rugs and Tile

If this appliance is installed directly on carpeting, tile or other 

combustible material, other than wood flooring, the appliance shall 

be installed on a metal or wood panel extending the full width and 

depth of the appliance. 
Attention:    Optional  SRS-18  and  SRS-30  Floor  Stand  meets 

requirement.
The base referred to in this section does not mean the fire-proof  

base as used on wood stoves.  The protection  is for rugs that are 

extremely thick and light colored tile. 

When facing the front of the appliance the following minimum clearances to combustible construction must be maintained.

Do not install in alcove or closet.

Provide adequate clearances around air openings. 

Adequate accessibility clearances for purposes of servicing and proper operation must be provided.

BF-10/BF-20

BF-30

Left side

5" (127mm)

8" (203mm)

Right side

5" (127mm)

8" (203mm)

Rear wall

0" (0mm)

0" (0mm)

Ceiling

36" (914mm)

36" (914mm)

Minimum vertical clearance from a projections above 

the appliance (shelves, window sills, etc.)

36" (914mm)

36" (914mm)

Floor (top surface of carpeting, tile, etc.)

2" (51mm)

2" (51mm)