Hampton Direct H15-NG1 사용자 설명서

Hampton

®

 H15-1 Direct Vent Freestanding Gas Stove

41

11) Carefully lift the burner tray assembly out. 

If your valve requires maintenance or replace-
ment,  use the following instructions:

1)  If optional fan is installed, disconnect power 

source to stove.

2)  Remove access panel.
 

3)  Disconnect gas line to stove.

4)  Disconnect 3/8" NPT pipe from 90

o

 elbow 

on valve or fl ex connector.

5)   Disconnect the two (2) switch wires from 

valve.

6) Disconnect 

piezo 

wire.

7)  Lift off Cast Top, remove Cast Front  and 

remove Glass Door. See the "Glass Replace-
ment" section for removal instructions.

8)  Carefully remove the logs and embers.

12) To remove the valve, remove the 4 screws  

(2 per bracket) that hold the valve to the 
valve bracket assembly.

13) To replace the burner tray assembly, simply 

reverse these instructions.  

14) Remove two (2) thermopile wires.

15) Remove thermocouple with a 9 mm (metric) 

wrench.

16) Remove pilot nut with an 11 mm wrench.

17) Remove valve to orifi ce nut with a 13/16" 

wrench.

18) Remove inlet pipe with pipe wrench. Note 

orientation of 90

o

 elbow.

19) Remove two (2) phillips head M5 screws on 

each side of the valve.

20)  Remove valve and remove gas out 90

o

 brass 

fi tting. Note orientation of fi tting.

1)  To install a new valve assembly, reverse 

instructions for Removing Valve.  

2)  Check for leaks and manifold pressure. See 

Gas Pressure Test  instructions.

3)  To reinstall valve, reverse instructions for 

removing valve assembly, steps 11-20.

9)   Remove burner by removing the 2 screws 

on each side, slide the burner to the left and 
then lift the burner tray out.

10) Remove all 8 screws holding the burner tray 

assembly in place. Remove defl ector.