Soleus Air KFTHP-24-ID 사용자 설명서
CONTENTS
Safety Precautions........................................................................1
Identification of Parts...................................................................2
Remote Controller........................................................................4
Operation Instructions..................................................................7
Maintenance.... ............................................................................9
Protection...................................................................................10
Troubleshooting..........................................................................11
Installation Instructions...............................................................12
Preparation Before Use
The remote controller is NOT preset
.
and should be set by owner
Note:
If the air conditioner you purchased is a Cooling Only one, but you pre-set the remote controller as Heat Pump,
If the air conditioner you purchased is a Cooling Only one, but you pre-set the remote controller as Heat Pump,
. But if the air conditioner you purchased is a Heat Pump one, and you preset the remote
controller as Cooling Only, then you CAN NOT preset the Heating operation with the remote controller.
it
will operate properly in cooling.
Remote Controller Pre-setting
Before using the air conditioner, be sure to check and pre-set the following.
Each time after the remote Control
or is energized,
.
User can preset the remote control type depending on the air conditioner type you have purchased
as follows :
as follows :
Press any button when the
flashes
.
If you dont press any button within 10 seconds, the remote controller is pre-set as Heat Pump automatically.
batteries are replaced,
the symbol will flash from
Cool
and HEAT
alternatively
heating symbol
,then Heat Pump is set
Press any button when the cooling symbol flashes ,then Cooling Only is set.
'
Auto-restart Pre-setting(optional):
the
the
is preset as Auto-restart function by manufacturer.If Auto-restart function is not needed, follow the
steps below to cancel this function:
1) Make sure the
1) Make sure the
power is
.
2) Keep pressing the Emergency button for more than 10 seconds until four short beeps are heard.
Then Auto-restart function is disabled. To activate the Auto-restart function, repeat above procedure until three
short beeps are heard.
Then Auto-restart function is disabled. To activate the Auto-restart function, repeat above procedure until three
short beeps are heard.
air conditioner
air conditioner
turned off at remote control
--This
is not intended for use by young children or
persons unless they have been
adequately supervised by a responsible person to ensure that they can use the
safely
--Young children should be supervised to ensure that they do not play with the
.
air conditioner
handicapped
air conditioner
air conditioner
Wiring connections must be tightly secured to all terminals.Loose connections can
result in electrical arcing,overheating and potential fire hazards.
result in electrical arcing,overheating and potential fire hazards.
CAUTION
Read all instruction manuals thoroughly before attempting installation.
The Manufacturer shall NOT be liable for any damages or loss due to improper
installation or operation or natural disasters.
Do not power the unit until all wiring,refrigerant tubing and refrigerant charging has been
checked and tested.
checked and tested.
Otherwise unit warranty will be void and serious damage to person and/or property may
Installation must be in accordance with this manual,NEC,State and Local Codes.
occur.
All units must be installed by a licensed contractor or technician.
Units must be grounded per current NEC,State and Local Codes.