Soleus Air GM-CAC-12SE 사용자 설명서

 13 

into 2 equal lengths. 

Remove the protective backing and apply it to 
the rear side of the cabinet side channels, 
starting just below the panel frame assembly. 
Pinch off excess length so the seal is even with 
the bottom of the cabinet side channel.

 

1. Remove the two front retaining screws from 
the front frame. 
2. Press firmly on each side of the metal case 
close to the front, approximately 2/3 of the way 
down. 
3. While pressing on the sides of the metal 
case, gently pull the front out and lift up to re-
lease it from the case.  
4. Then remove the four screws from the front 
frame to release the control panel box.

 

DO NOT push or pull the air direction 

louvers. 

It should sit 

on the platform assembly so that the window 
panel frame, and the cabinet side channels are 
against the top and side window jambs. Side 
channels should overlap side window jambs 
equally. 

in 

the top window jamb in line with the partially 
plugged holes in the panel frame. Secure the 
panel fame to the window jamb with two #8-
32x3/4-inch self-threading screws. If additional 
holding is necessary, two screws may be used 
on the sides of the panel frame as well. 

in the cabi-

net side channels (near bottom) and two 9/64-
inch diameter pilot holes in the side window 
jambs. Secure the cabinet side channels to the 
window jambs with two #8-32x3/4-inch self-
threading screws. When doing this, be careful 
not to twist the side channel seals with the 
screws. 

Inserting screws will prevent the air 

conditioner from being pushed into the room. 

First reconnect the coupler plugs, make the 
exhaust control positioned through the front 
in the proper location. 

 

Gently push the front into position on the cabinet. It 
should click into place. Then replace the retaining screws 
that holds the panel in place.