GE ASD06* 사용자 설명서

13

• Make sure the air conditioner plug is pushed completely

into the outlet.

• Check the house fuse/circuit breaker box and replace

the fuse or reset the breaker.

• The unit will automatically re-start in the settings last 

used after the power is restored.

• There is a protective time delay (approximately  

3 minutes) to prevent tripping of the compressor 
overload. For this reason, the unit may not start 
normal cooling or heating for 3 minutes after it 
is turned back on.

• Press the RESET button located on the power cord plug.

• If the RESET button will not stay engaged, discontinue 

use of the air conditioner and contact a qualified service
technician.

• Set the mode control at FAN or HIGH COOL with the

temp control at a warmer setting.

• Make sure there are no curtains, blinds or furniture

blocking the front of the air conditioner.

• Turn the temperature knob clockwise as far as possible. 

• Clean the filter at least every 30 days. See the Operating

Instructions section.

• When the air conditioner is first turned on you need

to allow time for the room to cool down.

• Check for open furnace floor registers and  

cold air returns.

• Set the air conditioner’s vent to the closed position.

• See “Air conditioner freezing up” below.

• Make sure there are no curtains, blinds or furniture

blocking the front of the air conditioner.

• Turn the knob counterclockwise as far as possible. 

The lowest setting provides maximum warming.

• Clean the filter at least every 30 days. See the Operating

Instructions section.

• When the air conditioner is first turned on, you need to

allow time for the room to warm up. 

• Check for open furnace floor registers and 

cold air returns.