Lopi Horizontal Or Vertical Vent Freestanding Stove Yankee Pellet Stove 사용자 설명서

Installation

(For Qualified Installers Only)

1 1

Travis Industries

4050418

1 0 0 - 0 1 1 5 6

Mobile Home Requirements

•

Outside air is required (used for
combustion) - see the directions
below.

•

The heater must be bolted to the
floor (Some states do not require
this; check with your local building
department). See the illustration
to the right.

•

The heater must be grounded to
the steel chassis of the mobile
home (Some states do not require
this; check with your local building
department).

WARNING:

DO NOT INSTALL IN
SLEEPING ROOM.

CAUTION:

THE STRUCTURAL
INTEGRITY OF THE
MANUFACTURED HOME
FLOOR, WALL, AND
CEILING/ROOF MUST BE
MAINTAINED.

7/16”

Socket

Remove the ash pan

(see page 29).

Use the lag bolts (used

to secure the stove to
the pallet) to screw the

pedestal to the floor.

Outside Air (used for combustion)

•

Must not be drawn from an enclosed space (garage, unventilated crawl space).

HINT:

Travis Industries strongly suggests outside air for all residential installations, especially for
those that are energy efficient, air-tight homes.

•

Must not be over 15'
long.

•

Must be made with 1 3/4"
diameter or larger metal
or aluminum duct with a
metal screen attached to
the end to keep out
rodents (P.V.C. or other
combustible materials
may not be used). We
recommend the Travis
Industries Outside Air Kit
(part # 99200136).

•

Must not terminate above
or within 1' of the
chimney termination.

•

Must have a rain cap or
down-turned elbow to
prevent water from
entering.

•

Must be located so that it
will not become plugged
by snow or other material.

13"

9-1/4"

AAA

AAAAA

AAA

AAAAAAAAAA

AAAA

AAA

AAAAAAAAAA

1-3/4" Diameter Flex Duct

Select a location

between framing

members for the
outside air hole.

Rain Hood with Rodent Screen

Silicone

Cut a minimum 2" diameter

hole in the wall.

Silicone

Seal the area around
the tube to prevent

air from entering

through the wall.

Silicone

AAA

NOTE:

This valve must be open (the rod
parallel with the tube) when the

stove is in operation.