Lopi Horizontal Or Vertical Vent Freestanding Stove Yankee Pellet Stove 사용자 설명서

4050418

Follow the instructions included with the remote thermostat for installation.

The remote thermostat has a 1 to 2 minute lag time between the time the thermostat is turned up and
the heater turns on.  Included with the remote thermostat is a set of instructions that details the
operating characteristics of this optional component.

1

Assemble the log shelf (with log shelf extender) following the directions below.

Right Log Shelf Leg

Left Log Shelf Leg

Log Shelf Cross Brace

3/8" Nutdriver

Nuts

Slide the log shelf extender onto the log shelf 
assembly.  Use a hammer to tap the extender 
fully into place.

Log Shelf 
Extender

The log shelf assembly should 
like like this when done.

2

Remove the firepot from the pellet stove.  Center the log shelf assembly (with extender attached)
over the burnpot holder.  Replace the burnpot.  Place the log on the log shelf extender.  When in
place the log should appear as shown in the picture below.

Center the log 

shelf over the 
burnpot holder.  

Slide it all the way 

back against the 

fireback.

Remove 

the 

burnpot.

Center the log on the log shelf 

extender and push it back so it 

rests against these two pins.

Replace the 

burnpot.

The log should look 

like this when 

installed.