Heatiator ECO-ADV-WS22 사용자 설명서

26

Heatilator • ECO-ADV-WS22 • 7057-128C • August 13, 2010

Marginal Location:

•  Below peak

Location NOT recommended:

•  Not the highest point of the roof

•  Wind loading possible

Multi-level Roofs

Windward 

Leeward

Recommended:

Outside Air Intake

on windward side

NOT recommended:

Outside Air Intake

on leeward side

Recommended Location:

•  Above peak

Recommended:

•  Insulated exterior chase 

in cooler climates

Recommended Location:

•  Above peak

•  Inside heated space

Location NOT recommended:

•  Too close to tree

•  Below adjacent structure

•  Lower roof line

•  Avoid outside wall

Marginal Location:

•  Wind loading possible

Follow manufacturer’s instructions for clearance, secur-

ing flashing and terminating the chimney.

  • 

Must have an approved and Listed cap

•

Must not be located where it will become plugged

by snow or other material

•  Must  terminate  at  least  3  feet  (91cm)  above  the

roof

and at least 2 feet (61cm) above any portion

of the roof within 10 feet (305cm).

•  Must  be  located  away  from  trees  or  other  struc-

tures

Location  of  the  appliance  and  chimney  will  affect  perfor-

mance. As shown in

Figure 26.1 the chimney should:

 •  Install through the warm space enclosed by the build-

ing envelope. This helps to produce more draft, espe-

cially during lighting and die down of the fire.

 •  Penetrate the highest part of the roof. This minimizes

the affects of wind turbulence and down drafts.

 •  Consider  the  appliance  location  in  order  to  avoid

floor and ceiling attic joists and rafters.

 •  Locate  termination  cap  away  from  trees,  adjacent

structures,  uneven  roof  lines  and  other  obstruc-

tions.

Your local dealer is the expert in your geographic area and

can usually make suggestions or discover solutions that will

easily correct any flue problems you may encountered.

NOTICE: