Lopi Yankee PS 사용자 설명서

4080728

   :

Make sure the
heater has fully
cooled
(approximately 25
minutes) before
opening the door
and conducting
service.

Phillips 
Screwdriver

With the pawl free of the bracket, 

the door may be swung open. 

When securing 

the door, make 

sure the pawl fits 

over the bracket 

before tightening.

NOTE: Do not overtighten the pawl.  This can 

permanently damage the latch and 

prematurely wear out the door gasket.

Door 

Frame

Bracket  (attached to side of 

heater)

Pawl

Lock Nut

AAAA

AAAAAAAA

AAAAAAAA

AAAAAAAA

AAAAAAAA

AAAAAAAA

AAA

AAAAAAA

AAAAAAA

AAAAAAA

AAAAAAA

In rare cases the auger drop tube will become plugged with pellets.  If your heater fails to feed pellets (make sure
the hopper has pellets and the auger has been turning for 10 minutes after refueling), this is an indication of a
plugged drop tube. Follow these steps to clear the drop tube: a) Remove the screw on the drop tube; b) Slide
the fuel gate from the drop tube; c) Use a screwdriver to dislodge pellets from the top of the drop tube (make
sure to get both sides of the auger – you will get approximately 1/4 cup); and, d) Replace the fuel gate and
secure with the screw.

Earlier models do not have the fuel gate – proceed to step c to clear the drop tube.

   : Whenever the auger becomes jammed, it is an indication that the firepot has become plugged.

After clearing the pellets,    

     )   and review the operating

instructions to verify the heater is working correctly and pellets are not piling up.

A

A

AA

AA

A

A

NOTE: Make sure this gate can 

swing when in place.  If it is 

installed incorrectly, it will prevent 

pellets from feeding correctly.