Dansons Group V-50 사용자 설명서

 

Can

adian Comfort Industries      V05                                            

5                                         

 VULCAN “V” SERIES OWNERS MANUAL 

Copyright 2005                                                                     

Dansons Group Inc.

 

S

AFETY 

P

RECAUTIONS

  

. . . Continued

 

•  DO NOT operate the stove if the flame becomes dark and sooty or if the firepot overfills with pellets.  Push 

the OFF Touch Pad and inspect the heater.  (See Operating Your Stove). Soot or creosote may accumulate 
in the exhaust vent system when the stove is operated under incorrect conditions such as an extremely rich 
burn. The flame will have a lazy orange color with black tips. This indicates poor pellet fuel combustion. 

•  NEVER block free airflow through the open vents of the unit. The viewing door and ash pan must be closed 

and latched during operation.  

•  The pellet appliance exhaust system works with negative combustion chamber pressure and a positive 

chimney pressure, therefore the exhaust system must be completely airtight and properly installed. All 
exhaust system vent joints must be sealed, gas tight,  with HI-TEMP RTV silicone sealant, and/or at least 3 
sheet metal screws per joint and to the heater also. 

•  Your heater requires periodic maintenance and cleaning (Refer to ”Routine Cleaning” section of the 

manual). Failure to maintain your heater may lead to smoke spillage in your home.  

•  Disconnect the power cord from the electrical outlet before performing any maintenance.  Pushing ”OFF” 

Touch Pad does not disconnect all power to the heater. 

•  BEFORE carrying out any maintenance or cleaning, allow the heater to cool. Ashes must be disposed in a 

metal container with a tight lid and placed on a non-combustible surface or on the ground, well away from 
all combustible materials, pending final disposal.  

•  The exhaust system should be checked twice a year minimum for any build-up of soot or  

creosote. Do not touch the hot surfaces of the heater.  

 
Note: Canadian Comfort Industries grants no warranty, implied or stated, for the installation or  
           maintenance of your heater, and assumes no responsibility of any consequential damage(s). 
 
 
 
 

 
In accordance with the procedures and specifications listed in UL1482 – 1998 & ASTM E 1509-95, and  
ULC-S627-00 and ULC-S628-M93 for solid fuel room heater, the Canadian Comfort Industries pellet stove has  
been independently tested and listed by I.T.S. (an accredited testing laboratory) to UL, ULC and CSA standards. It 
is tested and listed for residential installation according to current national and local building codes as: 

•  A Freestanding Room Heater 
•  A hearth insert when installed into a masonry or factory built fireplace. 
•  A Mobile Home Heater. 
•  A Built-In Heater. 

 
The Safety Listing Label is located on the rear inspection panel for model FPP and on the side panel for model IPP.  
Please read the label carefully.  It contains important information about installation and operation of your pellet 
appliance.  Note that your STOVE’S serial number is located on the safety label. Your appliance serial number is 
preceded by a “WH-“ (example WH-00000)