Enviro EF2 사용자 설명서

REMOVAL:
When maintenance is required on the

unit the surround must be removed.

Follow steps 3 through 6 in reverse

order.
The side panel can remain attached

because they swing forward for easy

access (refer to Figure 37).

Installation

��

Figure 37: Side surround panel swings forward.

LIDER

AMPER

NSTALLATION

Not for installation in Germany.
This is used to regulate the airflow through the pellet stove.
1. Remove the slider rod (short rod with knob and nuts) from their package and open the left side

panel.

2. Remove the knob and outer nut from the knob. Push the rod through the hole in the slider. Place the

lock nut on the rod and tighten, leaving a

” (1 mm) gap between the slider and the other nut.

3. Make sure the slider moves freely. Close the side panel and tighten screws after placing the rod

through the panel. Screw the knob onto the slider.

��

Figure 38: Slider / damper assembly.

UBE

CRAPER

Put the stainless steel rod through the hole in the heat exchanger located behind the top louvers. Thread

the rod into the scraper plate, which is visible from inside the firebox by removing the top baffle.