Enviro EF2 사용자 설명서

Operating Instructions

1.  Check and fill hopper with pellets.
2.  Make sure unit is plugged into a working outlet.
3.  Switch the power on by pushing the ROCKER SWITCH to the 

MANUAL position.

4.  Turn  KNOB  B  to  the  12  o’clock  position.  (Lower  grade 

pellets may need a higher setting on the feed rate). 

NOTE: Unit will take longer to light if the hopper has been 

completely emptied or is the first fire up.

5. Approximately fifteen (15) minutes after the fire was lit, the 

GREEN LIGHT should come on. When the GREEN LIGHT 

position. Now the stove will shut-off automatically if the fire 

goes out.

6.  Wait until the fire is established, then turn KNOB B to the 

desired heat output. The stove may not be able to burn in 

the BLUE ZONE if poor quality wood pellets are being used. 

Adjust  the  slider-damper  to  the  appropriate  setting  (see 

“S

LIDER

/D

AMPER

 S

ETTING

” section.

KNOB “A”: Fan Controller.  By adjusting the knob you will vary the rate of airflow into the room by varying 

the speed of the convection blower. When you first start the stove, it should be placed in the “OFF” 

position in order to heat the unit as quickly as possible. Once the room has come up to temperature, the 

control may be set to a comfortable level. *Note:  The convection blower may cycle to high automatically 

depending on the setting of KNOBS A and B. This is a normal safety feature of the unit. 

KNOB “B”: Dia-A-Fire Heat Output Knob.  This knob controls the amount of heat output. The dial has a 

scale with the blue zone representing the coolest setting of the stove, and the red zone representing 

the hottest setting. The scale on knob “B” represents a range, not exact at times or fuel quantities.  

Wood pellets of differing quality may affect the performance of the stove.  If the stove has trouble 

operating at either end of its range, turn the heat output knob back slightly.

The AUTO/MANUAL SWITCH must be in the AUTO position during operation.  To turn the stove off, simply 

turn the HEAT OUTPUT knob (KNOB B) counter-clockwise until the knob clicks to the “OFF” position. This will stop 

the feed of pellets. The blowers will continue to run and cool the stove.

If the stove is left in the manual mode after the green light comes on, the auger will continue to feed pellets. Pellets 

may over flow the burn-pot after the fire goes out and also re-light.

The scale on KNOB B represents a range, not exact times.  Wood pellets of differing quality 

may effect the performance and/or the  heat output of the stove.  If the stove has trouble 

operating at the end of its range, adjust the heat output knob back slightly.

7