Honeywell MS-9200UDLS 사용자 설명서

Programming

100

MS-9200UDLS   PN 52750:A    11/04/05

3.6.9.2.4.2  Terminal 1 and Terminal 2
Service Terminal #1 is generally designated as the FACP primary phone line used 
for receiving phone calls from the service terminal (PC) being used for remote 
programming.  Service Terminal 2 is referred to as the secondary phone line.  
Pressing 2 for Terminal 1 or 3 for Terminal 2 while viewing Service Terminal 
Screen #1 will display the following screen:

Phone Number (Service Terminal)
The Service Terminal Phone Number will be used by the control panel to contact 
the service terminal.  Pressing 1 while viewing the Service Terminal # Screen will 
cause the following screen to be displayed:

A flashing cursor will appear in the lower left corner.  Enter the phone number for 
the service terminal by keying in the first digit, pressing the left arrow key and 
entering the second digit.  Continue this process until all desired numbers have been 
entered (maximum of 20 characters).  Press the Enter key to store the phone number 
in memory and return the display to the Service Terminal # Screen.  

Valid entries are 0 - 9 and A - F with the numeric digits as dialed numbers and 
letters representing the following functions:

• A = * on a Touchtone phone keypad
• B = # on a Touchtone phone keypad
• C = look for secondary dial tone for up to two seconds (then dial anyway)
• D = three second pause
• E = five second pause
• F = end of phone number (F is automatically entered for unused entry 

positions)

  SERVICE TERMINAL
1=PANEL ID
2=TERMINAL 1
3=TERMINAL 2

Service Terminal Screen #1

  SERVICE TERMINAL #
1=PHONE NUMBER

   PHONE NUMBER

20 NUMBERS MAXIMUM