Peerless Industries ST630 사용자 설명서

ISSUED: 02-05-09   SHEET #: 201-9421-9  06-03-09

Use a stud finder to locate the edges of the stud. Use of an edge-to-edge stud finder is highly recommended. 

Based on its edges, draw a vertical line down the stud’s center. Place tilt assembly (

B) on wall as a template, 

making sure that the two mounting holes are over the stud centerline. Level tilt assembly, and mark the center of 

the two holes. Drill two 5/32" (4 mm) dia. holes 2.5" (64 mm) deep. Make sure that the tilt assembly is level, secure 

it using two #14 x 2.5" wood screws (

G) as shown.

•  Installer must verify that the supporting surface will safely support the combined load of the equipment and all 

attached hardware and components.

•  Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the 

screws, greatly reducing their holding power.

•  Never tighten in excess of 80 in. • lb (9 N.M.).
•  Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder 

is highly recommended.

•  Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Install-

ers are responsible to provide hardware for other types of mounting situations (not evaluated by UL).

1