ADT Security Services 9600 사용자 설명서

3URJUDPPLQJ

0DLQWHQDQFH3URJUDPPLQJ/HYHO



8QLPRGH31&

Pressing 1 for Point Program, while viewing Maintenance Screen #1 will cause the 
following screens to be displayed:

Select the Loop, containing the device to be disabled, by pressing 1 for Loop 1 or 2 for 
Loop 2.  A screen will then be displayed, allowing the operator to select the type of 
addressable device to be disabled as shown in the following display:

Select the device type by pressing 1 for an addressable detector or 2 for an addressable 
module.  The operator will be prompted to enter the three digit device address as shown in 
the following example for a detector:

A flashing cursor will appear in the bottom left corner of the display, prompting for the 
three digit device address.  When the third digit is enter, 001 for example, a screen will 
appear which will allow enabling or disabling of the selected point, as illustrated in the 
following example:

Pressing 1 repeatedly will cause the display to toggle between Enabled Yes and Enabled 
No.

    PROGRAMMING
1=POINT PROGRAM
2=HISTORY
3=PROGRAM CHECK

Maintenance Screen #1

@@POINT@PROGRAM

1=LOOP@1

2=LOOP@2

@@POINT@PROGRAM

1=DETECTOR

2=MODULE

@EDIT@DETECTOR

ENTER@POINT@ADDRESS

***

EDIT@DETECTOR@1D001

1=ENABLED@@@@@@@@YES