Honeywell 25/50ZS 사용자 설명서

Audio Command Center Series Manual — P/N 51889:E1  6/8/2010

59

Installation

6. Secure the FC-XRM70 Transformer Module(s) to the Audio Amplifier Module(s) with the 

supplied screws.

The Local Playback Speaker Module can be used to monitor the recorded digital message without 
transmitting the message over the system speakers.  The speaker module plugs into P2 of the main 
circuit board.  This optional module is necessary to take advantage of the Playback feature.

The Speaker Module is connected by simply plugging the module connector into P2 of the main 
circuit board.  The Speaker Module may be temporarily installed during the test period by using the 
supplied mounting hardware.

1. Remove the main circuit board mounting screw located on the bottom center of the board.  

Refer to the illustration below.

2. Install the supplied metal standoff in the mounting hole just vacated in Step 1 and screw 

standoff into place.

3. Position the FC-LPS mounting bracket hole over the standoff and secure with screw removed 

in Step 1.

4. Plug the FC-LPS Local Playback Speaker Module's polarized connector into connector P2 on 

the main circuit board.  P2 is located on the bottom right of the main circuit board near the 
Control/Indicator panel.

Position standoff 
(Step 2)

Install standoff 
(Step 2)

Solder side

Secure with 
screw (Step 2)

Two Factory Installed Jumpers on P1 of Each 

Amplifier Module Must be Removed to Install 

the 70.7 V

RMS

 Transformer (Step 4)

Install Standoff in 
Mounting hole      
(Step 2)

Install Standoffs in 
Mounting holes (Step 2)

ac

2

5x

fm

n

.w

m

f

2

5

50

sn

t3

.w

m

f