MartinLogan Home Theater System 사용자 설명서

8

Position a black rubber spacer over the threaded hole in

the top of the speaker cabinet and carefully pivot the top

of the Script into the wall bracket. Carefully move the

speaker cabinet so that the center of the rubber spacer,

the top-support hole, and the threaded hole on top of

the Script cabinet are aligned. You may find it helpful to

secure the rubber spacer over top of the wall brackets

top support hole with loosely applied masking tape that

you can easily remove once the knob is in place. Insert the

male threaded knob through a fiber washer, the wall

bracket and rubber spacer, and into the speaker cabinets

threaded hole (see figure 7).

9

Install the female knob on the bottom of the Script by

threading a fiber washer onto the threaded stud projecting

for the bottom of the speaker cabinet, then screwing the

female knob onto the threaded stud (see figure 7).

10 Your Script is no mounted on the wall (see figure 8). To

direct the speaker at the listening position, loosen the

top and bottom knobs slightly and pivot the speaker to

the optimum angle. Re-tighten the knobs.

Figure 7.

Figure 8.