Marantz NR1402 사용자 설명서

50

Adjust the tonal quality of the sound.

Tone Control
Set the tone control function 
to ON and OFF.

ON : Allow tone adjustment (bass, treble).
OFF : Playback without tone adjustment.

 “Tone Control” can be set when “Dynamic EQ®” (

set to “OFF”.

The tone cannot be adjusted in the “DIRECT” mode.

Bass
Adjust low frequency range 
(bass).

 “Bass” can be set when “Tone Control” is set to “ON”.

Treble
Adjust high frequency range 
(treble).

 “Treble” can be set when “Tone Control” is set to “ON”.

Set Audyssey MultEQ®, Audyssey Dynamic EQ® and Audyssey Dynamic Volume®. These can be selected 
after Audyssey® Auto Setup has been performed. For additional information on Audyssey technology, 
please see 

.

• If you have not performed Auto Setup, or if you change the speaker settings after performing Auto Setup, 

you may not be able to select Dynamic EQ®/Dynamic Volume®.
In this case, either perform Audyssey® Auto Setup over again or perform “Restore” (

) to 

return to the settings after Audyssey® Auto Setup was run. 

• When HD Audio for which the sampling frequency exceeds 96 kHz is played back, the “Audyssey 

Settings” cannot be set.

MultEQ®
MultEQ® corrects both time 
and frequency response 
problems in the listening 
area based on Audyssey® 
Auto Setup calibration. We 
recommend “Audyssey”.
MultEQ® is the prerequisite 
function for Dynamic EQ® 
and Dynamic Volume®.

Audyssey : Optimize the frequency response of all speakers. 
Audyssey Byp.L/R : Optimize frequency response of speakers except 
front L and R speakers.
Audyssey Flat : Optimize frequency response of all speakers to flat 
response.
Manual : Apply frequency response set with “Manual EQ” (

OFF : Turn “MultEQ®” equalizer off.

• “Audyssey”, “Audyssey Byp. L/R” and “Audyssey Flat” can be selected 

after Audyssey® Auto Setup has been performed. “Audyssey” is 
automatically selected after performing Audyssey® Auto Setup. When 
“Audyssey”, “Audyssey Byp. L/R” or “Audyssey Flat” is selected, 

  

illuminates.

• After running Audyssey® Auto Setup, if the Speaker Configuration, 

Distance, Channel Level, and Crossover Frequency have changed 
without increasing the number of speakers measured, only 

 

illuminates.

• “MultEQ®” and “Manual” cannot be selected when “EQ Customize” is 

).

• When using headphones, “MultEQ®” is automatically set to “OFF”.

“MultEQ®”, “Dynamic EQ®” and “Dynamic Volume®” settings are stored for each input source.

vSee overleaf

BD