Runco LS-10I 사용자 설명서
Runco LS-10i Installation/Operation Manual
43
PRE
L
IMINAR
Y
4.1
Selecting An Input
Source
Selecting An Input
Source
When you turn on the LS-10i, it switches to the last selected input and looks for a valid
signal.
signal.
Use these buttons on the remote control to select an
input source directly.
input source directly.
You can assign the HD 1, HD 2 and HD 3 buttons to any
input, or to the Picture-in-Picture (PIP) function. The
default assignments are: HD 1 = Component 1,
HD 2 = Component 2, HD 3 = RGB.
input, or to the Picture-in-Picture (PIP) function. The
default assignments are: HD 1 = Component 1,
HD 2 = Component 2, HD 3 = RGB.
For more information, refer to HD 1 Key / HD 2 Key / HD 3 Key on page 66.
4.2
Selecting An Aspect
Ratio
Selecting An Aspect
Ratio
Use these buttons to select the appropriate aspect ratio
for the type of program material being viewed. Refer to
Table 4-2 for more information.
for the type of program material being viewed. Refer to
Table 4-2 for more information.
4.3
Selecting Video
Memory
Selecting Video
Memory
Press CUST1, ISF NIGHT, ISF DAY or CUST2 to recall
settings from a memory preset. Then, press ENTER to
confirm your selection. Or, to cancel the operation, press
settings from a memory preset. Then, press ENTER to
confirm your selection. Or, to cancel the operation, press
to select Cancel and press ENTER.
4. Operation
VID
S-VID
HDMI 1
HD 2
SOURCE
HD 1
HD 3
HDMI 2
ASPECT RATIO
16:9
VWIDE
LBOX
4:3
CINEMA
VCINE
2
1
PICTURE MEMORY
ASPECT RATIO
CUST1
ISF
NIGHT
ISF
DAY
CUST2