Sony HM-982RW 사용자 설명서
66
Preparation section
Basic section
Application section
Knowledge section
Convenient recording of CD player output
Twin recording onto CD-R/RW and Tape
(TWIN REC)
Check the current play mode of the CD player.
1
Make the preparations for recording.
Select the “CD” input. Be sure to put the CD recorder and cassette deck in stop mode.
All tracks in a CD can be recorded simultaneously on a CD-R/RW and tape at the normal speed. (All-track twin
recording)
It is also possible to record only the track being played from its beginning onto a CD-R/RW and tape simulta-
neously. (Single-track twin recording)
The recording source can be a finalized CD-R/RW, but digital-to-digital recording may not be available with
certain discs.”Digital recording and SCMS”
recording)
It is also possible to record only the track being played from its beginning onto a CD-R/RW and tape simulta-
neously. (Single-track twin recording)
The recording source can be a finalized CD-R/RW, but digital-to-digital recording may not be available with
certain discs.”Digital recording and SCMS”
A
All track recording
Single-track recording
If it is in play mode, stop it.
Select the desired CD track and play it.
2
CD
CDR
=
TAPE
STOP
7
6
CD
Before recording
This system can record signals on Normal (TYPE ) and
High (TYPE ) position tapes. Remember that the Metal
(TYPE
High (TYPE ) position tapes. Remember that the Metal
(TYPE
) tapes cannot be used with this system.
When digital-to-digital recording is not impossible
or when analog-to-digital recording is performed,
select the analog input as described in the follow-
ing section then start the setting from step
or when analog-to-digital recording is performed,
select the analog input as described in the follow-
ing section then start the setting from step
1
below.”Changing the recording input setting”
e
DIGITAL
The current setting is displayed.
"DIGITAL" is lit ......... Digital-to-digital recording
"DIGITAL" not lit ...... Analog-to-digital recording
"DIGITAL" is lit ......... Digital-to-digital recording
"DIGITAL" not lit ...... Analog-to-digital recording
÷ High-speed recording is not available in the Twin Recording
mode.
÷ When a CD-R/RW is loaded in the CD recorder, the CD-R IN
indicator may blink for a while.
“OPC (Optimum Power Control)”
“OPC (Optimum Power Control)”
‡
1 CDR ........Place a recordable CD-R or CD-RW disc.
fl
TAPE ...... Perform steps 1~3 of the procedure
in”Recording on TAPE”.
‚
2 Load the recording source disc in the CD player.
¢
Do not use a cassette tape with more than 90-minute recording time, for the tape used with such a cassette is very
thin and tends to cause troubles such as entanglement around the pinch roller or cutting of tape.
thin and tends to cause troubles such as entanglement around the pinch roller or cutting of tape.
CDR
÷ Even when the TWIN REC key is pressed in the middle of a
track, recording will start from the beginning of the track.