JVC TH-R1 사용자 설명서

Page 66April 8, 2005 4:00 pm

Filename [TH-R1R3EK_09Editing.fm]

Masterpage:Left+

You can use a camcorder as the source player and your unit as the 
recording deck.

Make connections.

A If the camcorder has no S-VIDEO output connector:

^ connect the camcorder’s AUDIO/VIDEO OUT connectors to 

the unit’s [VIDEO/AUDIO (L(MONO)/R)] input connectors on 
the front panel.

●

When using a monaural camcorder, connect its AUDIO OUT 
connector to the [AUDIO(L(MONO))] input connector on your 
unit.

B If the camcorder has an S-VIDEO output connector:

^ connect the camcorder’s AUDIO OUT and S-VIDEO OUT 

connectors to the unit’s [AUDIO (L(MONO)/R)] and [S-
VIDEO] input connectors on the front panel.

Press PR +/– to select 

AF-1B.

●

Set 

AF-1 INPUTB to AVIDEOB for the [VIDEO] input connector, or 

AS-VIDEOB for the [S-VIDEO] input connector, depending on the 
connector being used. (A pg. 69)

Press REC MODE repeatedly to set the recording mode. 
(A pg. 38)

Start playback on the camcorder slightly before the actual point 
from where you wish to start dubbing.

Press 

R on the unit to start recording. Or while holding R, press 

I on the remote control. The dubbing starts.

Upon completing dubbing, stop the unit and the camcorder.

●

Stop recording on the recording deck (your unit), then stop 
playback on the source player (camcorder).

●

All necessary cables can be obtained from your dealer.

●

Refer to the camcorder’s instruction manual for operating 
procedure.

●

The quality of the dubbed picture is poorer than that of the 
original.

A If the camcorder has no S-VIDEO output connector:

To [VIDEO/AUDIO

(L(MONO)/R)] input

Audio/video cable

(not supplied)

AUDIO/VIDEO OUT

B If the camcorder has an S-VIDEO output connector:

To [S-VIDEO]

input

To [AUDIO] 
input

S-video cable
(not supplied)

AUDIO OUT

Audio cable
(not 
supplied)

S-VIDEO OUT

TH-R1R3EK_00.book  Page 66  Friday, April 8, 2005  4:00 PM